Why USDT for top-ups
NoctHost runs a prepaid, USD-denominated balance. You send crypto, the confirmed amount credits in dollars, and servers bill hourly against it. With a volatile coin the credited dollar amount depends on the price at confirmation time. With USDT, what you send is what you get, minus network fees, which keeps budgeting simple.
It is also convenient if you already hold or earn stablecoins. No conversion, no bank, no card. Just a transfer that lands as account credit.
The top-up flow, step by step
- Register with just an email address. No KYC, no card, no phone.
- Open billing and choose Add funds.
- Pick USDT, then select the network you will send on (for example TRC-20 or ERC-20).
- Send your USDT to the address shown on the invoice, on that same network.
- Wait for network confirmations. The confirmed amount credits your USD balance.
- Deploy a VPS. It bills hourly against your balance until you destroy it.
Choosing the right USDT network
USDT exists on several chains. The token is the same dollar peg, but the address and the network are not interchangeable. The two you will see most often are TRC-20 (on Tron) and ERC-20 (on Ethereum). Cost and speed differ a lot between them.
- TRC-20 (Tron): typically the cheapest fees, usually a good default for a top-up.
- ERC-20 (Ethereum): widely supported but can carry high gas fees when the network is busy.
- Other chains may be offered too; whatever you pick, your wallet must send on that exact network.
The rule that protects your money is simple: pick a network at NoctHost, then withdraw or send from your wallet on that same network to the address shown. Mismatched networks are the number one way people lose a stablecoin transfer, and no host can reverse an on-chain mistake.
After it credits
Once the confirmations land, your USD balance goes up and you are ready to deploy. Servers bill hourly, so you can run a box for a few hours, destroy it, and keep the rest of your balance for next time. Top up again whenever it runs low; there is no subscription and no card on file that can fail.
Deploy in about a minute
The hardware under the balance is top-tier: NVMe storage, dedicated IPv4, clean IP reputation, 29 locations, and roughly 60 seconds from deploy to root SSH. Register with an email, fund with USDT on the network of your choice, and pay by the hour for exactly what you run.